Potenza 1000 VA (600W). Tecnologia Line Interactive ad onda sinusoidale con stabilizzazione di tensione. Filtri di protezione di linea telefonica o LAN . Batterie tipo "long-life". Autonomia 15 minuti al 50% del carico (aumentabile con box batteria opzionali). Batterie "HotSwap" sostituibili dall'utente. Display LCD con stati di funzionalità e parametri elettrici.
Grazie alla doppia interfaccia USB ed RS232, il dispositivo può controllare 2 PC distinti.
Software di shutdown automatico e diagnostica del server per Windows 95/98/2000 Linux e UNIX.

Caratteristiche tecniche

• Potenza: 1000VA / 600W
• Ingresso:
  • Voltage Single Phase; 220/230/240V selectable by DIP Switch (±25% )
  • HZ 50Hz/60Hz ±5%
• Usscita
  • Voltage(AC) Increase 15% (Input:-9% to -25%); Decrease 15% (Input:+9% to +25%)
  • Voltage(INV) Inverter mode:±3%
  • Waveform(INV) Pure Sine-Wave with THD 3% at linear load
  • Hz(INV) Inverter mode: 50Hz or 60Hz ± 0.1Hz
• Trasferimento: Line/Battery Nearly Zero Transfer (<6ms typical)
• Batterie:
  • Half-load runtime 9 min
  • Capacity 12V/7Ah
  • Quantity 2
  • Recharge Time 2-4 Hours to 90%
  • Type Sealed Maintenance Free Lead Acid VRLA Type
• Protezione:
  • Over/under Volt. Switch to Battery Output whrn the Utility over regulation range
  • Overload(AC/INV) >110% Buzzer continuosly alarms and shuts down after 10 minutes
  • Short Circuit(AC/INV) Input Fuse & Electronic Circuit / Electronic Circuit
  • Low Battery Two stages, no battery drain after cut-off
  • EMI/RFI Full time suppression
  • Surge Protection Meet with IEEE 587 cat. A&B Standard
  • Modem/Network RJ11 / RJ45
  • Energy Rating 960 Joules instantaneous response
  • Attenuation Better than 45dB @1Mhz for Normal/Common mode
  • Noise Filtering EN50991-1
• Connessioni:
  • Output 4*IEC(Battery Power Supply) + 1*Schuko
  • Computer RS232(DB9) and USB
• DISPLAY and DIAGNOSTICS: With LCD and LED Display
• LCD Display:
  • Status: Normal, AC Input High, AC Input Low, On Battery, Battery Low, Battery Bad, Overload, Fault, Phase error, Ground Fault
  • Data: Utility Voltage, Ouput Voltage, Output Hz, Load%, UPS Temperature, Battery Voltage, Runtime Timer
• LED Display
  • Green=Normal, Amber=Warning, Red=Critical
  • LCD shows detalis in respect to the lighting indication of LED
• Allarme acustico: Overload, Fault, High Temperature, Battery On, Battery Low, Battery Bad, Over/Under Voltage, Frequency Error
• Advanced Mode: Self-diagnostic; Direct Time-based readout of battery remained runtime
• Porte di Comunicazione: USB/DB9 port with TRUE RS232 serial signal plus dry contact signals
• Condizioni Ambientali: 0-40°C; 0-95% Non Condensing Humidity
• Certificazioni Sicurezza: CE/UL
• Dimensioni (L×A×P cm): 17×24×37
• Peso (Netto) Kg: 15